Second Generation Sprung Bed Slat Kit Single Row

Our Second Generation Slatted Bed Base is Designed and Manufacture in-house by our Design Team. We only use the highest quality components from specialist manufacturers; ensuring our finished product is built to last.

Our Second Generation Single Row Kit is ideal when manufacturing a new bed frame or for converting flat bed slats to sprung bed slats on an existing bed frame.  

Our Second Generation Single Row Kit consist of

2 Beech Ply Multiplex Rails; Pre-Drill to exect our Second Generation Holders
30 Quality Beech Sprung Bed Slats (53mm x 8mm)  - May vary depending on the length specified
30 Twin Slat Holders, which are doweled into the side rails using Pegs to add strength and durability

Techincal Information

Rail 50mm x 20mm x 2000mm

Height of Rail Including the holder - Approximately 67mm

Gap in between Slats  - Approximately 25mm

Optional Extras

Optional: Adjustable slat tension in the lumbar region

Second Generation adjustable tensions adjusters are placed in the lumber region to further improve your comfort level. These are also known as “rigidity adjusters”. There are three beech sprung slats per double slat holder with two second generation sliding tension adjusters. These tension adjusters in the lumber region, allow the sleeper to manually adjust the firmness of the bed in the lumbar region to their preference. Another added benefit is that you can adjust the tension independently from your partner.

Optional: Shoulder Zone Components 

Our Special Shoulder Zone Components are a silent system, which is spring free meaning it is noise free. These components are able to rotate on both sides, and are able to be pushed down up to 23mm including the rotation. This will dramatically improve comfort and reduce pressure in the shoulder region. 

Bed Frame (Measurments)

We offer a cutting service were we are able to cut the length of the rails to your exact length 

We are also able to cut the slat down 

Measure the inside edge of your size rail to the inside edge of the other side rail; minus 60mm

For Examples 

If  inside edge of your size rail to the inside edge of the other side rail is 900mm. You slats will need to be cut down to 840mm